Great replacement for Toyota belt tensioner pulley bearing on the 2GR-FE engine.
Needed quantity:2
Needed tools: 40mm Bearing press; or 3/8 threaded rod washers nuts and some sockets.
---- trailmug
Name : wusstig From : United Kingdom
Time : 2021/2/27 Review:★★★★★
Just what I needed to replace the load side bearing on a 3HP Pentair Intelliflo VS pump.
---- wusstig
Name : tigerseye From : Canada
Time : 2021/2/19 Review:★★★★★
Bought these to replace bearings in my 60 inch mower deck. Timken is a trusted name and was the main reason I purchased them.
---- tigerseye
Name : e***n From : Korea
Time : 2021/2/14 Review:★★★★★
Great price well packaged and arrived promptly - thank you!
---- e***n
Name : t***1 From : Brazil
Time : 2021/2/13 Review:★★★★★
Overall good arrived quickly. The bearings are unbranded so we will see how well they last but they went in without any issue. Unfortunately I couldn‘t use the seals as they fit the smaller bearings not the larger ones which is what I needed but that was my oversight I should have checked. If I need more I will buy again can‘t say fairer that that.
---- t***1
Name : n***_ From : Sweden
Time : 2021/2/06 Review:★★★★★
The package arrived a week late but that isn´t the sellers fault. The Swedish post just can´t handle the packages in time so I can´t blame the seller for this.
---- n***_
Name : 2***n From : Iraq
Time : 2021/2/01 Review:★★★★★
I would like to say that this contact GLUE is not one of the best. BUT IS THE BEST. I have tried them all. 100% the best....
---- 2***n
Name : 0***k From : Mexico
Time : 2021/1/26 Review:★★★
On the picture of the listing it shows 2 bearings and in the title it says “bearings” （plural）. This suggests you will receive more than a singular bearing. It‘s misleading and I assume the “company” name is designed to be misleading too as it says “（4 bearings）” in the description in brackets misleading you to believe you will receive 4 individual bearings when you will in fact receive a single bearing. Overall though the quality of the product is satisfactory and the price isn‘t bad.
---- 0***k
Name : J***a From : Netherlands
Time : 2021/1/25 Review:★★★★★
I was all set to use ball bearings in my application until I found these for such a reasonable price. They are smaller and stronger and a much better fit for the application. They appear to be very well built and for my application the loads won‘t be as high as these are rated to handle but the price was well within budget!
---- J***a
Name : T***m From : Switzerland
Time : 2021/1/17 Review:★★★★★
These bearing fit my 2008 Cub Cadet snow thrower. Drive shaft assembly needed one of these （outer） and two INA SCE 108 needle bearings （inner） for each end of drive shaft assembly for a total of 6 bearings. Cub Cadet techs will tell customers they need to replace whole drive shaft assembly when these bearings go bad （$250-275）. I had local auto parts store press out old bearings and press in new for nominal cost. Newer snow throwers （2012 & later） have sealed ball bearing upgrade.
Name : trailmug
